Kenwood TM-D710

To access Service Mode
- Make 6-pin data plug with pins 3 & 6 connected
- Plug into Data Socket on Main Unit
- Power up while holding Left 2 Function buttons
To set powers, rotate main knob to find “HPWR V” etc.
- Note current settings of all 6 parameters
  - HPWR V 216
  - MPWR V 148
  - LPWR V 137
  - HPWR U 225
  - MPWR U 106
  - LPWR U 83
- Adjust each to achieve required power (Press PTT, Look at Power meter, rotate Main Knob with relevant figure selected…..)
  - New settings (high power set to keep current below 10A)
    - HPWR V 172 → 25W (current 6.5A)
    - MPWR V 148 → 10W
    - LPWR V 137 = 5W
    - HPWR U 133 → 20W
    - MPWR U 102 → 10W
    - LPWR U 83 = 5W
- Power off
- Remove plug
- Power on