Arduino Project - Make It Tea

Try to learn something about everything, and everything about somethingThomas Huxley “Darwin's bulldog” (1824-1895)

Trace: • Shack To Makerspace • Repair and Service 2022 • Some QRSS Grabs • Seiko SKX007 • Measurements (2022) • IP Addresses • MB7AZE AllStar • GM4SLV Allstar 2025 • NXDN Bridging • Casio GW-M5610

You are here: Make It Tea » Public Area » Make It Tea Blog » Arduino Project

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.

====== Arduino Project ======




I dabbled with Arduino to build some small projects back in 2021, mostly using the SI5351 PLL chip. 

=== === 

A lot was learned from the You Tube channel, and blog, of Charlie Morris ZL2CTM

[[https://www.youtube.com/c/CharlieMorrisZL2CTM]] and  [[https://zl2ctm.blogspot.com/]].

I designed and built a 60m QRP SSB/CW/Digimode transceiver which started as a Direct Conversion DSB radio and then morphed into a superhet SSB rig with 9MHz IF and crystal filter. I was also was in the process of building a phasing RX and CW TX to make an HF CW transceiver - band TBC but it //was// working on 17m when I drifted off the path and abandoned radio for a while.

I've dug out the 60m rig and it's still working. I've got it in my new shack as a 60m monitor RX. One of its features is a "scanner" - just cycling around a selection of channels pausing for a second and moving on which is handy for spotting activity popping up on one or other channel.

Today I also went searching for the Arduino sketches for all my little experiments at the time, and found them on the old laptop I used in the shed-shack at the time. This laptop is physically decrepit - screen broken etc. - but can still be accessed over the LAN. I've retrieved all the sketches and they are linked at the bottom of the page.

It's been a while (5 years!) since I played with Arduino and the 5351 PLL, so I'm a little rusty, but I'm considering making a QRSS TX to run on 60m (I've begun [[..:radio:topics:arduino:qrss_tx|]] ) if I can find somewhere to put a small base-loaded vertical (perhaps a helical linear-loaded vertical?). The first step will be to write the Arduino sketch to make the 5351 make pretty patterns on a waterfall. Then a simple 500mW PA strip shouldn't be too difficult.

I still have some un-used Seeduino Nano boards and some 5351s, so I think I'll rig up a development board and start writing code. Small baby steps....



===== Further Information =====

  * My Ardiuno Code sketches: {{ :public:radio:topics:arduino_sketches.tar |}}




{{tag>radio arduino qrss homebrew}}

~~DISCUSSION~~

Navigation

Search

Toolbox