Try to learn something about everything, and everything about somethingThomas Huxley “Darwin's bulldog” (1824-1895)

Trace:

You are here: Make It Tea » Public Area » Radio » Radio Topics » Arduino Projects » 60m Transceiver

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision		Previous revision
public:radio:topics:arduino:60m_transceiver [11/07/26 10:30 BST] – [RX Only, with CW / SSB, and scan] johnpublic:radio:topics:arduino:60m_transceiver [11/07/26 10:44 BST] (current) – [Further Information] john
Line 5: Line 5:
  
  
-The 60m transceiver has the following features+The 60m transceiver has the following features, which vary according to the loaded firmware
  
   * Channelized operation   * Channelized operation
Line 18: Line 18:
   * Digital mode input/output and PTT via 9-pin D   * Digital mode input/output and PTT via 9-pin D
   * SSB Mic input via 8-pin round "Icom" connector   * SSB Mic input via 8-pin round "Icom" connector
-  * Modulation Source (Mic or Data) chosen via select switch+  * Modulation Source (Mic or Data) can chosen via select switch
   * Scan start switch - scan a preset group of channels - cycles continuously, no "squelch"   * Scan start switch - scan a preset group of channels - cycles continuously, no "squelch"
 +    * Use of Jenal SC2 CCIR493 Selcal microphone can be supported - including scanning
  
 ===== Arduino Versions ===== ===== Arduino Versions =====
  
-There are several different firmware versions....+There are several different firmware versions....this is just a sample...
  
-==== RX Only, with CW / SSB, and scan ====+==== RX Only, with SSB, CW & scan ====
  
 {{ :public:radio:topics:arduino:gm4slv_60m_channels_cwscan_noptt_new_calibration_130523.ino |}} {{ :public:radio:topics:arduino:gm4slv_60m_channels_cwscan_noptt_new_calibration_130523.ino |}}
Line 842: Line 843:
 ++++ ++++
  
-==== Full TX - with scan, SSB, CW, Datamode ====+==== Full TX/RX - with SSB, CW & Scan ====
  
 {{ :public:radio:topics:arduino:gm4slv_60m_channels_cwscan_ptt_new_calibration_230823.ino |}} {{ :public:radio:topics:arduino:gm4slv_60m_channels_cwscan_ptt_new_calibration_230823.ino |}}
Line 1667: Line 1668:
 Page updated : ~~LASTMOD~~ Page updated : ~~LASTMOD~~
  
-{{tag>}}+{{tag>radio arduino }}