Try to learn something about everything, and everything about somethingThomas Huxley “Darwin's bulldog” (1824-1895)

Trace: • Arduino Projects • Arduino Project • blog_history • QRP Labs QMX

You are here: Make It Tea » Public Area » Make It Tea Blog » Arduino Project

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision		Previous revision
public:blog:arduino_project [10/07/26 23:15 BST] – [Arduino Sketches] johnpublic:blog:arduino_project [12/07/26 08:27 BST] (current) – [Further Information] john
Line 19: Line 19:
 Today I also went searching for the Arduino sketches for all my little experiments at the time, and found them on the old laptop I used in the shed-shack at the time. This laptop is physically decrepit - screen broken etc. - but can still be accessed over the LAN. I've retrieved all the sketches and they are linked at the bottom of the page. Today I also went searching for the Arduino sketches for all my little experiments at the time, and found them on the old laptop I used in the shed-shack at the time. This laptop is physically decrepit - screen broken etc. - but can still be accessed over the LAN. I've retrieved all the sketches and they are linked at the bottom of the page.
  
-It's been a while (5 years!) since I played with Arduino and the 5351 PLL, so I'm a little rusty, but I'm considering making a QRSS TX to run on 60m, if I can find somewhere to put a small base-loaded vertical (perhaps a helical linear-loaded vertical?). The first step will be to write the Arduino sketch to make the 5351 make pretty patterns on a waterfall. Then a simple 500mW PA strip shouldn't be too difficult.+It's been a while (5 years!) since I played with Arduino and the 5351 PLL, so I'm a little rusty, but I'm considering making a QRSS TX to run on 60m if I can find somewhere to put a small base-loaded vertical (perhaps a helical linear-loaded vertical?). The first step will be to write the Arduino sketch to make the 5351 make pretty patterns on a waterfall. Then a simple 500mW PA strip shouldn't be too difficult.
  
 I still have some un-used Seeduino Nano boards and some 5351s, so I think I'll rig up a development board and start writing code. Small baby steps.... I still have some un-used Seeduino Nano boards and some 5351s, so I think I'll rig up a development board and start writing code. Small baby steps....
 +
 +(I've begun [[..:radio:topics:arduino:qrss_tx|]] )
  
  
Line 27: Line 29:
 ===== Further Information ===== ===== Further Information =====
  
-  * My Ardiuno Code sketches: {{ :public:radio:topics:arduino_sketches.tar |}}+  * My old Ardiuno Code sketches: {{ :public:radio:topics:arduino_sketches.tar |}}